• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Need Help How do I get my graphtec FC8600-130 out of digitizing mode?

Signgrl

Signgrl

New Member
I reset the plotter and now its crazier than ever. The command is HPGL like its supposed to be but says its in digitizing mode? How do I get it out of that and be a normal setup again? When I turn the plotter on it goes through its initialization then just starts cutting random stuff up the side of the material. It wont stop unless I turn the machine off.
 
Last edited:
You must log in or register to reply here.
Top