How to Create Tilt Mount

[SAR.Summerlin]

So we had a customer ask about creating a tilt sign for their menu boards. I was thinking of using a cable system but don't know where to begin researching sample and material or hardware.

Can you wonderful people point me in the right direction?

:U Rock:

 

[Guerilla Signs]

you might check http://www.outwater.com/

I think they may have the cable system you are looking for

 

[SAR.Summerlin]

I am uploading a crude drawing of what I am thinking of. I know I have seen this somewhere before.

Didn't see what I am looking for on Outwater but still browsing the site. I saw ceiling cable systems and wall but nothing quite like this.

 

[signage]

http://www.outwatercatalogs.com/lg_display.cfm/catalog/Master_2012/page/132

http://www.outwatercatalogs.com/lg_display.cfm/catalog/Master_2012/page/133

http://www.outwatercatalogs.com/lg_display.cfm/catalog/Master_2012/page/135

etc.

 

[John Butto]

displays2go.com

from one crude drawing to another...

 

[signage]

If the bottom is not attached to the wall what will keep it from sliding down?

You need either a ledge or the bottom of sign attached to the wall! If not any small force (air) will cause it to move fall against wall just hanging from cable system

 

[SAR.Summerlin]

If the bottom is not attached to the wall what will keep it from sliding down?

You need either a ledge or the bottom of sign attached to the wall! If not any small force (air) will cause it to move fall against wall just hanging from cable system

Sorry my drawing doesn't show the molding that is around the area the sign fits into I though I could either rest it against this with some rubber stoppers or somehow anchor it at the bottom just not sure how.