Question HP 800W water dispenser pump

[Zhivko Yanakiev]

Hi everyone.
I've just replaced the water dispenser pump and I think I should run it continuously until it fills up the hoses up to the needles. I ran several cleanings on the white PH but it doesn't seem to be efective enough.
So the first question is: Am I right in assuming that or the system will fill itslef up during printing/cleaning?
And the second question is: If I have to run the pump ''manualy'' does anyone know how to do that? I have access to the service menu but I can't find anything there.

 

[balstestrat]

Did you also replace the needles? I find that they clog on every single machine...

You can fill the system in diagnostic menu. You have to boot into it.

 

[Zhivko Yanakiev]

Yes, I did. Everything from the dispenser to the needles. Not sure that I understand this with the diagnostic menu but I will see tomorrow. Thanks!

 

[Zhivko Yanakiev]

Did you also replace the needles? I find that they clog on every single machine...

You can fill the system in diagnostic menu. You have to boot into it.

It's all good now. Thanks, again!