MonsterBabyBLN
New Member
new thread for this:
I am pretty desperate right now.
I have fixed this ISS problem where the printer would throw th 1:02:10 error...
but ever since.. initialization goes up to 95%.. and then the printer moves the drive roller fast forward a bit and swallows and stops with that error.
First I thought it was a hardware problem. something stuck.. I ve had funny noises before going forward never backwards..
I took all the gears off on the right side and cleaned and back together.
When I run the drive roller test.. the roller moves a little bit.. but the system says it didnt!
maybe some sensor is the problem ?.. I exchanged the motors.. no fix.
any advice ?
I am pretty desperate right now.
I have fixed this ISS problem where the printer would throw th 1:02:10 error...
but ever since.. initialization goes up to 95%.. and then the printer moves the drive roller fast forward a bit and swallows and stops with that error.
First I thought it was a hardware problem. something stuck.. I ve had funny noises before going forward never backwards..
I took all the gears off on the right side and cleaned and back together.
When I run the drive roller test.. the roller moves a little bit.. but the system says it didnt!
maybe some sensor is the problem ?.. I exchanged the motors.. no fix.
any advice ?
