Install new Graphtec fc9000 in Omega 5

[artofacks1]

Hello,

Our tech is out until Jan. 4th and I just got another Graphtec delivered to the shop. This one I want to use it with Omega 5 instead of Flexi. However, Graphtec 9000 isnt in the local list. Any insight would be appreciated.

Thanks!

 

[Pauly]

If it's not in the list, it's not supported. Different drivers etc.
Use CM4 or flexi.

 

[Joe House]

You can use the generic HPGL driver in Omega. Make sure that your plotter is set to HPGL command language.

Good luck

 

[artofacks1]

You can use the generic HPGL driver in Omega. Make sure that your plotter is set to HPGL command language.

Good luck

Which HPGL do you recommend? Thanks

Are you available for paid on the phone technical support?

 

[artofacks1]

If it's not in the list, it's not supported. Different drivers etc.
Use CM4 or flexi.

I do use Flexi with our Latex printer but would like to stay away from it as much as possible for our Edge Prints.

FYI : Flexi limits the print size and in Omega it is programmed to put the cut lines in front and back of job and still gives you full width. Another reason not to print from Flexi when paired with Graphtec.

 

[Joe House]

Since we're basically talking about an unsupported plotter in that software, you're going to have to try them out and see. Also, you'll likely not be able to make it read registration marks and cut Edge jobs without the "designated driver" . But you should be able to cut vinyl only jobs.

 

[michael Mahoney]

If it's not in the list, it's not supported. Different drivers etc.
Use CM4 or flexi.

flexi print dont come out as well as Omega for some reason

 

[Pauly]

flexi print dont come out as well as Omega for some reason

what doesn't come out as well

 

[Attila Nagy]

just choose the latest one you have in omega. Graphtec GP-GL or HP-GL commands did not change. Make sure in the cutter Select COMMAND to AUTO.

 

[michael Mahoney]

what doesn't come out as well

flexi prints on gerber edge fx when i use flexi i can cut on graphtec no problem cutting with omega to graphtec dosent seem to wanna cut

 

[michael Mahoney]

just choose the latest one you have in omega. Graphtec GP-GL or HP-GL commands did not change. Make sure in the cutter Select COMMAND to AUTO.

cutter is on auto