Is there a way when I run out of material to start where the job left off?

[Signguruniagara]

OK! Now I know what you're doing! LOL Click on the second tab..."panel tab" and just below that choose how you want to panel it and how many panels, etc. You can customize it also like below if I wanted to adjust the panel to be in-between the G and N, I can do that. Most important part >>>> OVERLAP!!!! Mine's set at .35" this will print the panels with a slight overlap. If you run out of material or screw something up you can go back and print any of the panels.

View attachment 177280

Hi Stacey,

Thanks for the reply. I tried this last night and when I started the print where my last roll left off every panel had a white line through it. Like a break between panels. Is there away to get rid of that?

 

[bdw99]

Hi Stacey,

Thanks for the reply. I tried this last night and when I started the print where my last roll left off every panel had a white line through it. Like a break between panels. Is there away to get rid of that?

Its gonna do that by default, you can play around with the amount of panels and size you want.