Latex 700 Overcoat still wet after drying

Brittni Reid

New Member
I am trying to print on Orafol Orajet 3165 with overcoat. After it cures, the ink/overcoat is still wet and scratches right off with barely any pressure. Im new to using a Latex 700 and the profile says that the overcoat is on. Looking to see if anyone has any ideas as to what the issue might be. I'm stumped and there isn't much on the internet when I look it up.

Thanks in advance!
 
Last edited:

balstestrat

Problem Solver
What is the overcoat and curing heat set at in the profile?
Overcoat should be 0.5 or 1.0. Raise the curing heat until it cures properly.
 
Top