bolankeith
New Member
Hi,
I have a Lynx plotter. I am using the updated cutter software (VXi 8.5) it was working fine then one day it said 'port error', so i had to reselect the port (Comm3) and now it recognizes it. so far so good. When i send a job through it scrolls fine, i get the notice telling me that it has cut 100%. But the cutter has not actually cut anything.
here are some specs that may be relevent - PC is a Dell Inspiron (2008), OS is Vista. I tried disabling firewall. I tried unchecking TCP/IP in the tool prefs.
any help is very much appreciated
I have a Lynx plotter. I am using the updated cutter software (VXi 8.5) it was working fine then one day it said 'port error', so i had to reselect the port (Comm3) and now it recognizes it. so far so good. When i send a job through it scrolls fine, i get the notice telling me that it has cut 100%. But the cutter has not actually cut anything.
here are some specs that may be relevent - PC is a Dell Inspiron (2008), OS is Vista. I tried disabling firewall. I tried unchecking TCP/IP in the tool prefs.
any help is very much appreciated