Good evening, I've been having a reoccurring issue with the 30f that I run where it thinks that the registration pins/media guides are still up despite all of them being down. Sometimes this sensor will kick off when waking up the machine from sleep mode after a lunch break so it's not just when messing with the registration pins.
Thankfully this issue doesn't happen in the middle of prints and tends to not happen for periods of time so it doesn't seem detrimental to the machine itself, it's just somewhat annoying when in a rush to pump out a project. Any tips would be much appreciated.
Thankfully this issue doesn't happen in the middle of prints and tends to not happen for periods of time so it doesn't seem detrimental to the machine itself, it's just somewhat annoying when in a rush to pump out a project. Any tips would be much appreciated.