Mesh banner edge finishing

[JohnBFryJr]

We have been using a third party for mesh banners. Ad Miracle out of Florida has done us a good job but now that we have purchased a printer I would like to print them in house just to save time.

Can anyone suggest ideas to finish the edges with tape or glue?

Thanks in advance.

 

[bannertime]

Depends on the purpose. However, the only time we use mesh is when it's a large/long banner. It always gets a nylon webbing with d-rings sewn into the corners, grommets through the mesh and webbing.

 

[JohnBFryJr]

Honestly we are on the coast so we sell alot of them to little league and the volunteer fire dept to put on fences. The banners we currently are getting are folded over and either glued or heated around the edges and grommets in the corner.