I have a barely used Mimaki CG130SRlll (1.5 yrs old) that is cutting way off when doing contour cutting.
I stumbled upon this 400mm square test cut and wanted to know if there is any info I could receive from anyone that could help me with this. It cuts the first decals fine, but gets progressively worse as it reaches the end of the job and far left corner of the vinyl. We are only talking about 4 ft of 54" wide material.
Thank you in advance.
I stumbled upon this 400mm square test cut and wanted to know if there is any info I could receive from anyone that could help me with this. It cuts the first decals fine, but gets progressively worse as it reaches the end of the job and far left corner of the vinyl. We are only talking about 4 ft of 54" wide material.
Thank you in advance.