Hi everyone....we are using a Mimaki CG-75FX, we never had before this need but now we have a huge job that we just found and there is no CROP MARKS...so now we need to place the sheets one by one...our problem is that we are looking to move the blade (during a pause) while the job is on...without re-positioning the sheet from the beginning...we can move it...but it always re-starts where it was....is it possible to change cutting position (blade)while on hold somebody have a hint!!!
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Mimaki CG-75FX....re-positioning while cutting
- Thread starter rascal
- Start date