The error message that comes up in Raster is: Mimaki Jv3: DRV: An error has occurred during output(O). <Bus reset occurred {-536412148} > - [Terminate] - (0x02018003)
Only recently I have been experiencing issues while printing on my Mimaki Jv3. I primarily use Onyx for RIP but also have the same problem when printing through RasterLink, which lead me to believe it's a communication issue between computer and printer. I have since rebooted both and switched ports on both. I will wait to see if the issue occurs again, but wanted to see if anyone else has experienced this.
Thanks!
Only recently I have been experiencing issues while printing on my Mimaki Jv3. I primarily use Onyx for RIP but also have the same problem when printing through RasterLink, which lead me to believe it's a communication issue between computer and printer. I have since rebooted both and switched ports on both. I will wait to see if the issue occurs again, but wanted to see if anyone else has experienced this.
Thanks!