Mimaki JV33-160 parameter

[Elie]

Hello Guys,
I want parameter mimaki jv33-160 ss21 Firmware 5.70
I habe error X over current, yesterday I was printed no problem
today when turn on the printer i have this error
I checked all cables and reconnect cables

 

[Smoke_Jaguar]

Might be a jammed up motor pulling too much current and tripping the error.

 

[Elie]

I want to check the parameters first because i didn't have a new motor to test
Do you have

Might be a jammed up motor pulling too much current and tripping the error.

 

[Smoke_Jaguar]

See if you can turn the motor freely by hand with the power switched off.

 

[Robert M]

Wipe the encoder with a clean rag, look for ink spots on the encoder

 

[Elie]

See if you can turn the motor freely by hand with the power switched off.

Yes I tried, no problem it's soft freely

 

[Elie]

Wipe the encoder with a clean rag, look for ink spots on the encoder

It's X axis problem not Y motor
But also i tried that

 

[Pregasen]

It's X axis problem not Y motor
But also i tried that

Hi. Did you come right with getting parameters. I am also in need of parameters

 

[Smoke_Jaguar]

Hi. Did you come right with getting parameters. I am also in need of parameters

Parameters are machine specific, best bet is to contact a Mimaki tech or dealer to get a copy for your specific machine serial number. They will be factory parameters, so they will be outdated most likely, but better than trying to start with some from another machine. Best practice is to back that up any time the machine gets a firmware update.