Mimaki ucjv300-160 Print Cut circles on gold foil

[Reproman]

Trying print/cut Mimaki UCJV300-160 1 inch circles using Orafol 351-911 gold foil media The Mimaki UCJV300-160 prints fine on this media, but it does not cut correctly-image is not centered. Tried different sizes crop marks, thicknesses, print, then cut etc.
Any suggestions other than purchasing an auxiliary plotter?

 

[Smoke_Jaguar]

A nice large white patch behind the cut marks goes a long way, but I typically generate cut files outside Rasterlink. Easy workaround is plop down a white sticker as it's printing on the 4 corners (pause print for safety) in each corner for good contrast, so the marks read better.

Also, a dedicated Mimaki section exists on the forum at https://www.signs101.com/forums/mimaki.208/