reklamdizains
New Member
Hi,
We just got our Mutoh Spirtfire 65, tehnician replaced heads, but didn't calibrate them. We ran out of money, but we need to get printer going..
What can we do with our hands to get it right? I added picutre, so you can see, it prints double lines.. Also head alignment test is wrong, all lines are the same, not like in instruction manual.
Can you please help with it and write step by step what to do? I must keep printer going as soon as possible.. Thank you in advice
It runs with Onyx Ripcenter 6.5 if its naccesary to know.
We just got our Mutoh Spirtfire 65, tehnician replaced heads, but didn't calibrate them. We ran out of money, but we need to get printer going..
What can we do with our hands to get it right? I added picutre, so you can see, it prints double lines.. Also head alignment test is wrong, all lines are the same, not like in instruction manual.
Can you please help with it and write step by step what to do? I must keep printer going as soon as possible.. Thank you in advice
It runs with Onyx Ripcenter 6.5 if its naccesary to know.