Neil
New Member
Thanks guys, I haven't had chance to test it with the new cut length yet.
I use Signlab which has the half cut commands the same as via Graphtec. The beauty of Signlab is you can send a print/cut/perf cut job all in one go.
Wooly I understand what you mean by the blades getting damaged by turning. It'd be like drilling little holes in the cutting strip.
Sorry to the OP for ruining your thread!
I'll let you know if I have success...
I use Signlab which has the half cut commands the same as via Graphtec. The beauty of Signlab is you can send a print/cut/perf cut job all in one go.
Wooly I understand what you mean by the blades getting damaged by turning. It'd be like drilling little holes in the cutting strip.
Sorry to the OP for ruining your thread!
I'll let you know if I have success...