Need Help New pump fitted to SP300v. Was the old pump. Settings?

[DiS]

Have finally replaced the old version pump with a new version after a bit of ink pooling
in the cap tops. I know this machine is old but the time I had it has never gaven me issues
so why replace!

Anyway I believe a service mode setting needs selecting to prevent over use of ink
on cleaning. I have the 6.9 firmware. Anybody help with the setting please?

Thanks

 

[Solventinkjet]

Enter the Service Mode and change the System Switch on page 12, bit 1 (the first digit on the right) from a 0 to a 1

To enter service mode:

Start with the main power switch on and the sub power off

Push the following buttons in order: Down, Right, Left, Up, Right, Down, Left

Then push and hold these buttons while powering on: Left, Down, Right

You have to get it all in within 5 seconds so it might take a couple tries.

 

[DiS]

smashing, thanks. Can get into the service mode ok. Just a question how do I know its page 12?

 

[Solventinkjet]

smashing, thanks. Can get into the service mode ok. Just a question how do I know its page 12?

It should show on the screen like this:

 

[DiS]

ah right....Appreciate your help. Thanks