I have a no heat condition in the print area.
1) Fuses Good
2) Dryer area comes up to temperature
3) When machine starts up, display shows heater area heating up to 108 degrees, but area remains cold
4) In service mode with heat on, the print area does heat up
5) When you leave service mode, print area cools down to room temperature
So at this point I'm stumped. Roland tech in our area has never seen it before
1) Fuses Good
2) Dryer area comes up to temperature
3) When machine starts up, display shows heater area heating up to 108 degrees, but area remains cold
4) In service mode with heat on, the print area does heat up
5) When you leave service mode, print area cools down to room temperature
So at this point I'm stumped. Roland tech in our area has never seen it before