• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Omega and Roland

Tollef

New Member
Hi everyone, I have access to a copy of Omega 2.0 and was wondering if I could cut directly to a Roland CX 24 or do I need to use a program such as CoCut.

Thanks...
 

Fred Weiss

Merchant Member
Not sure why but most major brands are supported in Omega except Roland. You can drive Graphtecs and Summas ... even Zund flatbeds. It would have to be driven by selecting an appropriate generic HPGL plotter from Omega's available list.
 

Tollef

New Member
Okay thanks Fred, I was flip flopping between the CX 24 and the Summa D60...I've read good things about both but it seems the D60 would be favoured on this board.
 

WVB

New Member
CX-24 has been upgraded to the GX-24 which features faster cutting speeds and higher down force pressures.
 
Top