-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
ORAJET® 3551RA and 215 Gloss Lamination
- Thread starter marsuni
- Start date
GraphixGirl79
New Member
Maybe the pool was too cold? 
but on a serious note.. are you letting your prints gas off for a minimum of 24 hours? Which part is shrinking? the laminated media or only the laminate itself? With 3551 RA you are supposed to "post heat" everything to certain temperature so that it retains it's applied memory and not it's original memory , ie. shrinkback to original state.
We use 3551 mostly instead of the RA and haven't had a problem with shrinkage...
but on a serious note.. are you letting your prints gas off for a minimum of 24 hours? Which part is shrinking? the laminated media or only the laminate itself? With 3551 RA you are supposed to "post heat" everything to certain temperature so that it retains it's applied memory and not it's original memory , ie. shrinkback to original state.
We use 3551 mostly instead of the RA and haven't had a problem with shrinkage...
marsuni
Unitype-GR
The shrinkage is done during aplication. Even we use Epson S80600 we let 3551 outgass for 12+ hours.
I tried το applicate on a Square Bond 103x103cm. The Printing surface was 103,5 x 103,5 cm but at the direction of appliance was lost over 1cm. Strange to me!!!
Finally we heated the material to cover the diffrence!
I tried το applicate on a Square Bond 103x103cm. The Printing surface was 103,5 x 103,5 cm but at the direction of appliance was lost over 1cm. Strange to me!!!
Finally we heated the material to cover the diffrence!
