overspray on black head jv3-160s

[Spencer McMurtry]

i am getting overspray on the black head on a jv3-160s was woundering if anyone had any ideas on what is causing it.. i have replaced the dampers and raised the bulk ink tanks i have also did a head soak for a hour and a half. here are the pictures

slant adjust http://infinitegraphics.net/jv3_problems/slant adjust.jpg

fine y si http://infinitegraphics.net/jv3_problems/fine y si.jpg

print at 720x720 16 pass http://infinitegraphics.net/jv3_problems/black overspray.jpg

Thanks,
Spencer

 

[SAS]

Have you replaced the wiper?

 

[Spencer McMurtry]

Have you replaced the wiper?

yep

 

[brentp]

I too would change the wiper. If you use solvent make sure you use Black wipers.

 

[Spencer McMurtry]

I too would change the wiper. If you use solvent make sure you use Black wipers.

if is a new wiper, but a white one.. i have never seen black wipers? the only black ones i have seen are for rolands and they are not designed for full solvent

 

[Spencer McMurtry]

UPDATE!! the head carriage was not level i took a piece of material 1.45mil thick and set the heads on it and retighted all the screws and this fixed the problem! solution was from mike at merrit graphics

 

[Samurai_Screwdriver]

UPDATE!! the head carriage was not level i took a piece of material 1.45mil thick and set the heads on it and retighted all the screws and this fixed the problem! solution was from mike at merrit graphics

Taking advice from Mike Falia?! Oh no, now your machine is in serious trouble