TomK
New Member
Quick question about perf cutting with Flexi and the Graphtec FC8600.
Do I need to run the material through twice to get a perf cut? Do my contour cuts first, change blade position, and then run it through again?
Trying to nail down this process and do some testing this weekend, watched some videos and such, but they never stated if that was the process.
Thanks!
Do I need to run the material through twice to get a perf cut? Do my contour cuts first, change blade position, and then run it through again?
Trying to nail down this process and do some testing this weekend, watched some videos and such, but they never stated if that was the process.
Thanks!
