Nismoasfuh
New Member
Hello all, so I'm finally getting into perforated window film and ordered a roll of what was described as a 70/30. I have a roland sp540v and in versaworks there was a setting for 3m perforated 50/50 (rather than using the "general vinyl 1" I normally use). It printed much more vivid and used a lot more ink, but had not dried, the ink was still wet to the touch. I know the default setting for the print heater is 98 ̊F (37 ̊C) and the dryer 104 ̊F (40 ̊C )
I'm curious as to what HEATER/DRYER settings you guys use for perforated? Also, is it necessary for me to get the correct media profile for my specific media? Or should I be able to get away with the 50/50 setting for now?
I'm curious as to what HEATER/DRYER settings you guys use for perforated? Also, is it necessary for me to get the correct media profile for my specific media? Or should I be able to get away with the 50/50 setting for now?