• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Plotting from Omega to a Graphtec?

GoodPeopleFlags

GoodPeopleFlags

New Member
We just got a new Graphtec plotter (FC7000 42") and are trying to figure out how to send cutting jobs from Omega 2.61 to it. The manual shows how to do it from Illy or Corel but we think there's got to be a way to do it directly from Omega without having to convert jobs and then open them in one of those programs.

Any suggestions? :thankyou:
 
signage

signage

New Member
Make sure you set the plotter to HPGL and there should be a drive in Omega if not use generic HPGL.
 
You must log in or register to reply here.
Top