qucik printing question.

[Turbophein]

i just recently noticed that my print carriage goes the full length of my printer even on small 14" jobs??? i remember it stopping after the print area and returning not going the full length on every pass. i just did a test print for the cut config and it did short passes not full... so what gives? i did have to restore all my setting last month, maybe i missed something???

i have a sp300v

thanks

 

[Mike_Koval]

there is a Full Width S setting in the menu...you can set it to sheet or off. Sheet will go to the Pinch rollers and off will go to the end of the graphic being printed.

 

[Turbophein]

thank you so much! still lots to learn 2 years later!