• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Need Help Question about Plotter blade for my Grapthec 8600

Annette Asberg

New Member
Hi I need help to get the right blade for my 8600. I need one that can cut deeper than the CBO9UB-1 and I can't find any information on Grimcos website


New Member
Take a look at this PDF I have attached. It describes every blade they offer, and what it's used for. Spend a few minutes to determine which one is right for you.

(Edit: FYI, most folks use the CB15 for their thick material, make sure you switch to the red-tip bladeholder).


  • CP+Blades+and+Blade-Holders+HiRes.pdf
    472.1 KB · Views: 327