Dice
New Member
From time to time we get these black squares on the print using RasterLink3.
It ruins the print. I normally reprint a pdf from the pdf and the second time its fine. Today there was an entire line of Squares and rectangles on some store window graphics we did. Didn't catch it until the print is done. I'm about to dig into the file and see if i can find anything that would cause this.
The squares are normally black and about and inch by an inch. Today they were white on one print and multi colored on the other. They look like screwups on the rip. They are not visible in the file.
Anyone else have this issue?
It ruins the print. I normally reprint a pdf from the pdf and the second time its fine. Today there was an entire line of Squares and rectangles on some store window graphics we did. Didn't catch it until the print is done. I'm about to dig into the file and see if i can find anything that would cause this.
The squares are normally black and about and inch by an inch. Today they were white on one print and multi colored on the other. They look like screwups on the rip. They are not visible in the file.
Anyone else have this issue?