scogre
New Member
I have been cutting for about 24 hours with my new Graphtec CE5000-60 and loving it.
After struggling with Flexi for Mac for a while, I've switched to cutting in RoboCut. So I've run into a little snag that is more of an annoyance rather than a killer issue.
In Flexi, you can set the plotter to position at the end of the cut, at the end of the cut. In RoboCut, it returns to the original position.
I can't find a setting inside RoboCut to do the same thing. Anyone have a suggestion? I would really appreciate the help.
Thanks.
After struggling with Flexi for Mac for a while, I've switched to cutting in RoboCut. So I've run into a little snag that is more of an annoyance rather than a killer issue.
In Flexi, you can set the plotter to position at the end of the cut, at the end of the cut. In RoboCut, it returns to the original position.
I can't find a setting inside RoboCut to do the same thing. Anyone have a suggestion? I would really appreciate the help.
Thanks.