• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Roland SC 540 Does 1 pass & once it gets to the left hand side and printer turns off

H

hickeyink

New Member
Had a head strike today, turned printer off and then back on. Went to print something again, did a few passes, and something has shorted and turns the printer off. I tried it a few more times, and keeps doing it. Anyone know what it could be? head cables, scan motor? Help Needed urgently! Any ideas welcomed please!
 
I

InkjetAuction

New Member
Linear Rail?

In my 7+ years of servicing Roland printers, I have only seen happen this once in the field.

Turned out to be the linear rail being out of alignment... just enough to cause an electrical to chassis rub during the scan and a resulting short to ground. This turns off the machine like a light switch.

Not a typical adjustment. I advise for you to seek an experienced tech.

~E
 
You must log in or register to reply here.
Top