Need Help roland sc545ex roland service call 0108

[CUBICHE]

Hi, I was changing the cap top. Place the printer on cleaning and pass the 30min time. Now I have this service call 0108. Any suggestion.
Thanks

 

[Active Sign]

Turn off switch on back and fire it back up in 5 minutes. Should reset everything.


Sent from my iPhone using Tapatalk

 

[CUBICHE]

Hi , thanks.
I try that and the message is coming back, I will try again. Is something to do with the wipers?

 

[Active Sign]

Hi , thanks.
I try that and the message is coming back, I will try again. Is something to do with the wipers?

Not sure. I'd have to check the service manual. There may be another issue tripping a sensor. Unplug and start over.

Anytime I run into errors like this a full shut down usually gets it back up and running unless there is another problem.


Sent from my iPhone using Tapatalk

 

[Active Sign]

Code 0108

Description
Wiper Unit Protection Error
Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not become to reach the expected value.

Causes
Disorder of Wiper Height Sensor Fault of Wiper Unit Fault of Wiper Height Sensor Disconnection or short-circuit of Cable and Flexible Cable


Sent from my iPhone using Tapatalk