bayviewsignworks
New Member
First we now have a new SG-300 using the VersaWorks Dual. So far so good, but -
1) there are no profiles available and the four that came with the machine really aren't enough, where can I find the "stock set" like what came with VW?
2) when the sheet cuts and I feed it back through to contour cut, it gives me a "short sheet" error as it didn't pay out enough media at the end of the sheet to cover the media sensor.
3) does it really need that much extra media at the beginning of the print? It's like 2" longer than the SP series - I just lost like 5% on each run.
1) there are no profiles available and the four that came with the machine really aren't enough, where can I find the "stock set" like what came with VW?
2) when the sheet cuts and I feed it back through to contour cut, it gives me a "short sheet" error as it didn't pay out enough media at the end of the sheet to cover the media sensor.
3) does it really need that much extra media at the beginning of the print? It's like 2" longer than the SP series - I just lost like 5% on each run.