Rotate nested job in production manager

[Mata]

Is there a way of rotating a job once printed and sent to the cutter?

Basically, I've printed a nested job fine, I've cut it off the printer and there's not enough at the end of the print for the cutter. If I can rotate it 180 degrees it will work fine. I just can't work out how to rotate it other than if I rip it again.

Thanks

 

[Solventinkjet]

Tape some scrap vinyl onto the end of your print. It will give the printer enough to grab onto and trip the sensor so you can finish the cut. I've done it plenty of times!

 

[signheremd]

Tape some scrap vinyl onto the end of your print. It will give the printer enough to grab onto and trip the sensor so you can finish the cut. I've done it plenty of times!

or put a piece of masking tape over the back electric eye - this will fool it into thinking it has lots more vinyl on the roll.

 

[Joseph44708]

or put a piece of masking tape over the back electric eye - this will fool it into thinking it has lots more vinyl on the roll.

If you don't have a 3"tail it will feed past the grip rollers.

 

[MikePro]

I've taped-on tails plenty of times
Other times, i'll just deselect portions of my print&cut, to only cut the front-end first before rotating my page and outputting the remainder of my cuts.

 

[signheremd]

If you don't have a 3"tail it will feed past the grip rollers.

Apparently he has something like 3" as if he rotates it it will cut. BTW, if you 2" on a Graphtec you can make it work...