2B
Active Member
we have a Drytac JetMount
Model: jm63-sha-ha
needing the service manual on how to adjust the feed tension for vinyl
the issue is it is not feeding the vinyl squarely. we have tried different sleds, feed rates, starting the vinyl at an angle, trying different areas on the rubber wheels, etc. regardless of what we try, the vinyl shifts L to R when you are looking at the front of the machine.
The lamination is tracking squarely, or we are assuming it is since the waste backer is in line with the start roll. showing no shifting or walking on the tension rolls
Model: jm63-sha-ha
needing the service manual on how to adjust the feed tension for vinyl
the issue is it is not feeding the vinyl squarely. we have tried different sleds, feed rates, starting the vinyl at an angle, trying different areas on the rubber wheels, etc. regardless of what we try, the vinyl shifts L to R when you are looking at the front of the machine.
The lamination is tracking squarely, or we are assuming it is since the waste backer is in line with the start roll. showing no shifting or walking on the tension rolls