randyiawoa
New Member
Hey all! First post, having an issue here.
We just got our first Solvent (Eco) printer, a converted SJ-500, now SC-500 that was steal. We've been printing great with it for a week now, but have been trying to find the best color profile for it. We seemed to oddly enough find a good one that was in Colorprint labeled Generic. We had printed a corn hole board on Photo, trying to find the right settings, then found super was 720x720 while photo was 1440x720. So we tried super, and it ends up for the first 1-2inches having a green tone. This is pretty bad when our blues are green. It only happens for the first few inches, no more after that. And so far, its only with this mode. Any clue? We can try a different ICM profile, but really like the color this one gives out across the board on all of our materials. But, should we need to change it, gladly will.
Thanks!
We just got our first Solvent (Eco) printer, a converted SJ-500, now SC-500 that was steal. We've been printing great with it for a week now, but have been trying to find the best color profile for it. We seemed to oddly enough find a good one that was in Colorprint labeled Generic. We had printed a corn hole board on Photo, trying to find the right settings, then found super was 720x720 while photo was 1440x720. So we tried super, and it ends up for the first 1-2inches having a green tone. This is pretty bad when our blues are green. It only happens for the first few inches, no more after that. And so far, its only with this mode. Any clue? We can try a different ICM profile, but really like the color this one gives out across the board on all of our materials. But, should we need to change it, gladly will.
Thanks!