I'm noticing some banding with my Soljet Pro III that occurs only with certain colors ( or at least is more noticable ).
I've done the feed calibration ( of course ), slowed head speed, raised/lowered temps, switched to unidirectional mode -- makes some slight differences, but it's still there.
I'm really only noticing this on IJ180. I'm using the latest 3m profile. Matte finish vinyls print perfectly ( I wish IJ180 came in matte...)
See photo here: https://www.dropbox.com/s/v0l4drc3bly4gms/20130917_072959.jpg
On a side note, does anyone have a service manual they can share?
I've done the feed calibration ( of course ), slowed head speed, raised/lowered temps, switched to unidirectional mode -- makes some slight differences, but it's still there.
I'm really only noticing this on IJ180. I'm using the latest 3m profile. Matte finish vinyls print perfectly ( I wish IJ180 came in matte...)
See photo here: https://www.dropbox.com/s/v0l4drc3bly4gms/20130917_072959.jpg
On a side note, does anyone have a service manual they can share?