SP300i - Driver Install

[GW]

I switched from a SP300v to SP300i.

For cutting, I've always used SignLab CutPro. With the SP300v, I had the "port location" set to USB0002 and it would cut direct via USB, no issues.

With the SP300i and it's ethernet-based connection, I cannot get SignLab to work - there is no valid port. I tried adding a TCP/IP port based on the IP address of the printer to no avail.

Has anyone had any experience with this?

Thanks.

GW

 

[GW]

I think I figured it out - using TCP/IP Raw. Unless someone has a better suggestion.

Thanks!