Speaking of Gandi - Lamp Temps

[cwb143]

This may be a question that Merrit can answer. But I was wondering what is the general Rule of thumb for Temperatures on the Jeti3150x2. Some decided that 60 Trailing 20 leading was the right way to go. A licensed Tech said it was the opposite. but 60/20 seems to work on sintra, styrene and vinyl acrylic. Dosnt scratch off. So is that all im looking for is a scratch test? I know if its too low like a 20/30 the print can look wet like not cured well. So I rarely would run something that low I think.