Spooler 99% CPU usage after tranfer is complete!

[Little City Signs]

Ok, so I've got my spooler running buffering to the rolland pnc 1100, but even after the job is 100% sent to the plotter the spooler is still using 99% of the cpu! What is this about? I've been using signlab and the spooler for years and just today it seems to have started this.

Any sugestions?

 

[schmitty]

I have personally experienced this, and in my case it was due to an outdated video driver.

If you have recently updated signlab try updating your video drivers.

If all of the sudden this happened... I am not sure... maybe uninstall and reinstall signlab.


Good Luck!

 

[Rod]

Sounds like IDLE CPU resources

I took a quick look at the CADlink Knowledge Base (cadlink.com >> Support/Training >> Knowledge Base) and found this article. This sounds like what you're describing:

http://www.cadlink.com/support_train/technote.php?tn=1770


Cheers,

Rod at CADlink