Squeegie marks on lam'd window perf application

[Chuck Taylor]

Last week we did a large DRY installation of window perf using Contravision Performance 60/40 with DOL 1360Z OPTICALLY CLR overlam. It went on nicely but a week later we are still seeing squeegie marks from the application (we used a soft felt squeegie to apply). Has anyone else experienced this with this material and will it eventually settle in and the marks disappear? Thank you in advance for your feedback! I'm trying to reassure our customer that these marks are only temporary...

​

 

[ikarasu]

Usually after it's in the Sun for a day or two they go away. Does it have access to direct sunlight? If not it should still go away it just takes longer.

You could always use a heat gun and low and heat up a little area and see if it goes away if you're concerned, but 99 out of 100 times it will go away on its own

 

[crashaffinity]

Usually after it's in the Sun for a day or two they go away. Does it have access to direct sunlight? If not it should still go away it just takes longer.

You could always use a heat gun and low and heat up a little area and see if it goes away if you're concerned, but 99 out of 100 times it will go away on its own

this has been my experience

 

[TheAngryCanadian]

I agree with Ikarasu , a couple days and you’ll be just fine. Depending where you are the warmer it is the quicker those squeegee will disappear