suggestions on Tangled Up name

[Dzrt1st]

Excellent job on the scissor.

I'd use VHB tape or screws from the backside.

I would add a piece of blue vinyl "hair" over one blade of the scissor.

 

[slappy]

Thank you.

do you think the 3m tape will hold it up to weather though. I know it's great tape cause it's on all the truck accessories we sell. But i'd hate for it to fall and break.

I thought about screwing it into the board also. I just wanted to see if there were any other options

I'll do the blue hair thing when it's all done and secured.

 

[signmeup]

Remove the screw in the centre of the scissors and bolt it to the sign through the hole in the middle.

 

[signmeup]

OOps. Didn't realize the scissors were fake. Same advice applies. Drill through centre screw and and screw to sign.

 

[signage]

Nice job slappy! VHB tape then dill some small holes through the sign into the sign foam and pin with some small nails with glue.