Summa F1612 0,5'' PVC routing

[JustynaM]

Hi,
I'm new. I just start work at the sign shop. I need to cut 0,5''PVC on summa F1612 and my question is. If i choose in the default settings 0,512 and PVC is 0,5 does it mean it will go through the matt? After 3 weeks guy who normally operates the summa went for vacation so I have to do this and he told me to not change anything. So I guess if I go with his setting everything should work. I'm using a bit 590-9864. Any suggestions I would appreciate. Just don't want to drill hole in the table LOL.

 

[White Haus]

I'd be less concerned about your media thickness that you select and what your down position is set to. If anything selecting a slightly thicker media will just result in more passes, assuming it will default to multi-pass.

Are you using a sacrificial mat / spoilboard between the conveyor belt and your 1/2" PVC?

Otherwise, that stuff will cut like butter once you get going.

 

[JustynaM]

I'd be less concerned about your media thickness that you select and what your down position is set to. If anything selecting a slightly thicker media will just result in more passes, assuming it will default to multi-pass.

Are you using a sacrificial mat / spoilboard between the conveyor belt and your 1/2" PVC?

Otherwise, that stuff will cut like butter once you get going.

Yes I have a mat under the PVC. I can change to multi-pass too.

 

[JustynaM]

Yes I have a mat under the PVC. I can change to multi-pass too.

I'd be less concerned about your media thickness that you select and what your down position is set to. If anything selecting a slightly thicker media will just result in more passes, assuming it will default to multi-pass.

Are you using a sacrificial mat / spoilboard between the conveyor belt and your 1/2" PVC?

Otherwise, that stuff will cut like butter once you get going.

Thank you.