okeesignguy
New Member
Head was leaking....I replaced the dampers...fired the printer up and...
This is the message I am getting..."TEMPERATURE IS TOO LOW"
I have tried resetting it by unplugging it for a while with no luck...
What could this be...?
Here is the original thread...
http://www.signs101.com/forums/showthread.php?t=87341
Thanx !!!!!!!!
This is the message I am getting..."TEMPERATURE IS TOO LOW"
I have tried resetting it by unplugging it for a while with no luck...
What could this be...?
Here is the original thread...
http://www.signs101.com/forums/showthread.php?t=87341
Thanx !!!!!!!!