• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

To Overlap or not to overlap in VersaWorks

E

EbsWeb5150

New Member
I have a document that is 82" width x 94"L. I'm going to be splitting the graphic into two panels 41"W x 94"L mounted on a piece 4ftx8ft .020 styrene that will need to be cut to a panel size of 41"W x 94"L (qty. 4 cut to that size)

The question is should I set this graphic up in VersaWorks with a top left overlap? or set it to no overlap? I'm stumped. Would a overlap even
work in this case?
 
You must log in or register to reply here.
Top