Our shop's Mimaki UCJV300-130 has been getting a motor x 401 error, From everything I read it said to start with the belt tension and try to adjust that. I did that and now when I turn the machine on I get System halt 1 for the slider board. I checked fuses, none were blown. I was told by another tech that it could be the cable between the main board and slider board but I'm not finding that connection. Does anyone here have a service manual or a wiring map of this machine or any tips on what to try next?
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
UCJV300-130 Motor X 401 & System halt (1) 1C3:PCB SLDR2H
- Thread starter mpikowski
- Start date
Smoke_Jaguar
Man who touches printers inappropriately.
Never seen that caused by tension unless someone was doing something crazy. If it's moving somewhat and then erroring out at speed, probably a bad motor.
Service manual section on the error.
Due to an INSANE number of private messages this week, this is all I can offer for free help.
Service manual section on the error.
Due to an INSANE number of private messages this week, this is all I can offer for free help.
Last edited:
Thanks for the help, I appreciate it. Yes the tension was loose so I tightened it up. At first it was the 401 now a system halt. It was starting to move but now it does nothing at all. I looked at the cables, no disconnect or burnout. So it may be a motor replacement.