• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Upgrade Suggestions?

J

junaid

New Member
Hello all,

I am looking to upgrade from my Graphtec CE6000-60. I mainly cut MX decals up to 20 mil thick, but as low as 10 mil. Even with a 60 degree blade and max force, I feel that the cutter is operating at its limit.

I am also looking to move onto a 54" wide platform rather than printing everything in 24". My budget is around $5,000 and am looking to buy used. I'm looking mainly at the graphtec FC8600-130.

Any suggestions or feedback?
 
You must log in or register to reply here.
Top