VersaWorks Gurus,
I'm printing and cutting 3inch round magnets (Magnum DigiMag 0.20 if you must know) and I'm having to have the printer cut twice around each magnet. This is okay but here's the funny part. The printer goes through the first cut pass on each "print" and then returns to the first print on the first row (front right corner if facing the printer) and begins the second pass cut.
I'm noticing that the second cut may not line up perfectly with the first cut. Make sense?
Is there a setting (somewhere) to have the printer make both cut passes before progressing to the next print?
Thanks!
I'm printing and cutting 3inch round magnets (Magnum DigiMag 0.20 if you must know) and I'm having to have the printer cut twice around each magnet. This is okay but here's the funny part. The printer goes through the first cut pass on each "print" and then returns to the first print on the first row (front right corner if facing the printer) and begins the second pass cut.
I'm noticing that the second cut may not line up perfectly with the first cut. Make sense?
Is there a setting (somewhere) to have the printer make both cut passes before progressing to the next print?
Thanks!