• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

What are those for ?

F

French guy

New Member
I bought a VS300 praticuly new from a guy, the printer came with these two parts (see picture) . Anyone can tell me what is for ?
 

Attachments

  • IMG_2926.jpg
    IMG_2926.jpg
    38.7 KB · Views: 93
T

TonyC

Guest
You will find what they snap to located on the same rail as the wheels. They are for holding down the edge of banner material and keeping the loose fibers on banner material from touching the print heads. As mentioned above, remove before using sheet cut or you'll be replacing the cutter blade.
 
T

Tony McD

New Member
You probably have two short ones on it now at each end of the pinch rollers.
Pull the short ones off, and use the long ones for banner material.
 
Mike F

Mike F

New Member
fmg said:
Banner media clamps.Dont cut the media after printing or your in real trouble.
Click to expand...

If it were an older machine you'd be right, but the VS series will actually detect them, beep, and display a message to remove them. Once they're removed and you close the front cover it sheet cuts as usual. Do it all the time.

They also don't come with short media clamps, just the long ones pictured.
 
You must log in or register to reply here.
Top