DRPSignsNGrafix
New Member
Printing a couple basic banner yesterday it gave me the y error in the middle of the 2nd banner. Ok Cleared the job, started it again this morning. Printed 2 banners good no problem. Went to start printing another banner job. gets about 24 inches into banner gives me the same code. Clear everything out and send job again. Same thing about 20" into job. Any ideas? Yes been keeping the 2 rods oiled while it's printing.
I had a mutoh at my old shop. Just took over here and they have a Mimaki Jv3-160
I had a mutoh at my old shop. Just took over here and they have a Mimaki Jv3-160