• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Need Help Arizona 2380 GTF - Fotoba Mark issues.

S

Shawnski

New Member
We've been having issues printing panels with Fotoba marks. The panels center when we specifically justify them left. We're printing on an Arizona 2380 GTF using Onyx Rip 21. Anybody out there know why this might be happening?
 
Last edited:
S

SignMeUpGraphics

Super Active Member
As Pauly mentioned above... the Arizona will center anything sent to the RMO. You could fudge it by mounting the roll off-centre if you really need to, but it would be job-width dependent.
 
Pauly

Pauly

Printrade.com.au
Shawnski said:
Yes on the RMO. It seems that Canons software is over-riding how we are justifying in ONYX
Click to expand...
Yep. I had this issue too.
Can be annoying.

As Signmeupgraphics mentioned.
Offset the roll.
I've done it a few times. It works.

When im printing something that's smaller that the fotoba will struggle to slit, i'd print the start of it.
Stop it
mark where the fotoba mark is
unlock the shafts
slide the stock across till it's near the end and lock it back up.
 
S

Shawnski

New Member
Pauly said:
Yep. I had this issue too.
Can be annoying.

As Signmeupgraphics mentioned.
Offset the roll.
I've done it a few times. It works.

When im printing something that's smaller that the fotoba will struggle to slit, i'd print the start of it.
Stop it
mark where the fotoba mark is
unlock the shafts
slide the stock across till it's near the end and lock it back up.
Click to expand...
Yes, definitely a bit annoying.
That's clever, thank you
 
You must log in or register to reply here.
Top